#Shutter counter update#
#Shutter counter manual#

If manual operation switches ( Switch or Button pairs) are also used, additional input GPIO are required. With four shutters, eight Relay components are needed. If you intend to remove shutters, explicitly remove each one beginning with the highest numbered shutter. When a shutter is added or removed, a list of the active shutters, with their parameters, is output to the log. If the disabled shutter is restored, the higher numbered shutters previously declared will also be restored. Additional shutter declarations must be sequentially numbered, and without gaps (i.e., second shutter is 2, next shutter 3 and finally shutter 4).ĭisabling a shutter in the middle of the defined set of shutters will disable all other higher numbered shutters. To enable additional shutters, ShutterRelay must be executed for each additional shutter.

If possible to avoid any injury on unexpected movement all RELAYS should start in OFF mode when the device reboots: PowerOnState 0Ī maximum of four shutters per device are supported. Now ShutterPosition 0 will open the shutter and ShutterPosition 100 will close the shutter.īy default, only Shutter1 is enabled when SetOption80 1 is invoked. Only the interaction with the user and other systems changes.

All internal calculations are the same (the log output is the same). Then tell Tasmota to reverse the shutter position meaning via the ShutterInvert 1 command. If you need the position values reversed ( 0 = open, 100 = closed), define and calibrate your shutter as documented below. ShutterPosition 0 means the shutter is closed and ShutterPosition 100 means the shutter is open. The shutter reports its position and can also be sent to a dedicated position.

#Shutter counter update#

The driver takes care of the direction and proper update of the shutter position. In momentary mode (i.e., stepper motor), the relays start or stop the motor. Turning a device relay on or off directly (i.e., using Power) will function to affect a shutter's movement. Even if the shutter does not have two motors, three wires have to be connected. Wiring diagrams for Normal, Stepper motor, and Short Circuit-Safe configurations are available at the end of this page.

SetOption15 0 (required to store value and make it reboot save).

PWMfrequency 200 ( This is mandatory for most relay to get correct PWM duty cylces).

Relay1: ON/OFF, Relay2: UP/DOWN (optional not used) Shutter mode 5 - Servo Motors (PWM position based servo)

PWM: Stepper signal, COUNTER: Stepper position signal.

Relay1: OFF/DOWN PULSE, Relay2: OFF/UP PULSE

The examples below are for a ShutterRelay1 1 configuration (using Relay1 and Relay2). We recommend at least for Shutter mode 1 to define an Interlock setting. Additionally you can define PulseTime on any relay to change the relay into a pulse relay where the pulse changes start/stop. There are five shutter modes which define how the relays operate.

Smart Home Integrations Smart Home IntegrationsĬontrol blinds and roller shades connected to regular ON/OFF motors,stepper motors or position servosīefore starting you have to enable shutter support with SetOption80 1 Commands ~Ĭomplete list of commands is available at Blinds, Shutters and Roller Shades Commands.

Shutters and Blinds Shutters and Blinds Table of contents.